Modern thermostat learning curve

When I had my new furnace installed in October, we were still having warm days, but the evenings were quite cool and the temperature inside my brick house stayed fairly consistent. I had set the touch screen thermostat on Heating Mode with an upper cut-off and it worked well.

Then we had a some very warm days a couple of weeks ago and when I walked through the dining room, I saw the temperature inside was 77 degrees; I thought I was getting a bit warm and the room seemed close. I’ve written about the segment where we found out the Cooling Mode was connected incorrectly and so no matter what amount of fiddling I did with the thermostat, the outside unit would not come on. It was fixed, for free, and I decided to go to the Auto Mode. And, I need remedial thermostat training.

Actually, I don’t think I ever understood the ins and outs of this thermostat; there had not been a quiz. It appears there are periods of the day and you set what temperature you want during those time periods. I tried it and, frankly, it got fairly cold one night.

I started fooling around with the thermostat again – and “fooling around” is the most accurate way to describe what I was doing – and made things worse. It seems you can add as many periods as you want, and name them if you so desire. (Awake, Sleep, Away, Home, Work, etc.) Finally, I found out it was possible to delete periods as well. This was fortunate because somehow I had filled up the thermostat window with lots of periods, each wanting to have a temperature designated.

What I want to do is set temperature that triggers the heating mode and, if necessary, the cooling mode. I may have to consult YouTube. It will probably work out, assuming I do not let my AmeliaJake-ness take over and make a bunch of time periods that I can name, such as George, LaTisha, Harvey, Annabelle, Jack. I know that’s not right, but it is so tempting.